Kenwood KIV-BT900 - Manual (Page 11)

English | 11
• Connect the speaker wires correctly to the
terminals to which they correspond. The
unit may be damaged or fail to work if
you share the
- wires or ground them to
any metal part in the car.
• When only two speakers are being
connected to the system, connect the
connectors either to both the front
output terminals or to both the rear
output terminals (do not mix front and
rear). For example, if you connect the
+
connector of the left speaker to a front
output terminal, do not connect the
-
connector to a rear output terminal.
• After the unit is installed, check whether
the brake lamps, blinkers, wipers, etc. on
the car are working properly.
• Reception may drop if there are metal
objects near the Bluetooth antenna.
Bluetooth antenna unit
About CD players/disc changers
connected to this unit
If the CD player/ disc changer has the “O-N”
switch, set it to the “N” position.
The functions you can use and the
information that can be displayed may differ
depending on the models being connected.
For Good Reception
To assure good reception, note the
following:
• Communicate with the cell-phone within
the line-of-sight distance of 10 m (30
ft). The communication range becomes
shorter depending on the surrounding
environment. The communication
range also becomes shorter when there
is an obstacle between this unit and
the cell-phone. The above maximum
communication range (10 m) is not
always assured.
• A broadcast station or walkie-talkie
located nearby can interfere with
communication due to too strong signal.
¤ CAUTION
Install this unit in the console of your
vehicle.
Do not touch the metal part of this unit
during and shortly after the use of the
unit. Metal part such as the heat sink and
enclosure become hot.