Knoll Systems HT200 - Manual (Page 28)

Troubleshooting
This section helps you resolve problems while setting up or using your projector.
Common Problems & Solutions
Problem
Check These Items
Does not turn on Check that the cord is plugged in and that the power
switch on the back panel is on. (See page 13.)
Check the status light to see if the projector has
overheated or the lamp usage exceeds 1100 hours.
(See pages 29 and 30.)
No picture Use the menu icons to select your source (Video, S-
Video, or RGB). (See page 13.)
Ensure your cables are connected properly. (See
pages 6 to 11.)
Adjust the brightness and contrast. (See page 24.)
Remove the lens cap.
Is the STATUS indicator blinking? (See page 32.)
Image isn’t square to the screen Reposition the projector to improve its angle to the
screen.
Picture is blurred Adjust the focus. (See page 14.)
Reposition the projector to improve its angle to the
screen.
Ensure that the distance between the projector and
screen is within the adjustment range of the lens.
(See pages 8.)
Remote control does not work Install new batteries. Low batteries may activate the
laser but be insufficient to generate IR commands.
Make sure there are no obstacles between you and
the projector.
Stand within 13 feet (4m) of the projector.
The STATUS indicator is lit or blinking See the Status Light message chart on the next page.
Cross color in RGB mode If “Auto Picture” is off, turn it on. If “Auto Picture”
is on, turn it off and balance the image with the
Picture Adjustment icon and Fine Picture Adjustment
icon. (See page 26.)
28