Knoll Systems HT200 - Manual (Page 20)

Setting "INPUT MODE" to "YCbCr" or Component Video
When you have connected the component video (YCbCr) signal output jacks of the video
component to the RGB IN connector on the unit (see page 10), set "IMAGE MODE" to "YCbCr"
to obtain better picture quality.
1. Select the input source RGB (see page 13).
2. Press MENU to display the main menu.
3. Press the cursor up or down key to select "IMAGE ADJ MENU."
4. Press L-CLICK to display the IMAGE ADJ MENU.
5. Press the cursor up or down key to select "IMAGE MODE."
6. Press L-CLICK to display the IMAGE MODE menu.
7. Press the cursor up or down key to select "INPUT MODE."
8. Press the cursor +/- key to select "YCbCr."
9. Press L-CLICK
The change of settings will be confirmed.
When you display the IMAGE MODE menu next, the following IMAGE MODE menu for
YCbCr will be displayed.
Note: After disconnecting the video component from the RGB IN connector and reconnected a
computer set "INPUT MODE" to "RGB" in step 8 above.
Adjusting the image from the source connected to the RGB IN connector
The Projector selects the most suitable resolutions as shown in the "Timing Chart" below
according to the incoming signals from the RGB IN connector (When "RGB" is set to
"STANDARD." See page 22). However, you may need manual adjustment depending on the
computer or video component connected to the RGB IN connector (see page 10). If you have any
of vertical banding, noise, dot interference, or crosstalk on the projected picture, adjust clock
frequency with "PICTURE ADJ" then clock phase with "FINE PICTURE" (see next page). You
can also adjust the horizontal and vertical position of the image (see page 26).
Quick starting the projector
The projector can be turned on by switching the main power on the unit (see step 1 on page 13).
There is no need to press the remote control POWER ON button or the projector POWER button.
1.
Press MENU to display the main menu.
2. Press the cursor up or down key to select “POWER MENU.”
3. Press L-CLICK to display the POWER MENU.
4. Press the cursor up or down key to select “AUTO START,” then press the cursor + key to
select “ON” to activate the function.
To deactivate this function, set “AUTO START” to “OFF” by pressing the cursor – key.
Adjusting the image from the source connected to the RGB IN connector
The Projector selects the most suitable resolutions as shown in the "Timing Chart" below
according to the incoming signals from the RGB IN connector (When "RGB" is set to
"STANDARD." See page 26). However, you may need manual adjustment depending on the
computer or video component connected to the RGB IN connector (see pages 11 and 12). If you
have any of vertical banding, noise, dot interference, or crosstalk on the projected picture, adjust
clock frequency with "PICTURE ADJ" then clock phase with "FINE PICTURE" (see next page).
You can also adjust the horizontal and vertical position of the image (see page 22).
20