Kenwood KCA-S220A - Manual (Page 4)

4 KCA-S220A
7 Installing the switching unit on the carpet under a seat
• Velcro strips are used to install the switching unit in a simple manner. To install the switching unit securely, use of self-
tapping screws is recommended.
• Install the switching unit ! in places that do not obstruct driving.
• Install the switching unit ! in places where it is not touched by the tip of the shoes of a rear seat passenger.
Route cables so that they are not caught in slide rails.
• Do not install the unit in places where it is exposed to direct sunlight, high heat, or where water may splash over it.
• Do not place anything on top of the switching unit !.
Installation
7 Installing the switching unit with a board in the trunk space
Connection
Self-tapping screw $
( φ 4 × 16 mm)
Switching unit !
Board etc.
thickness: 17mm or more
1 Install the switching unit with self-tapping
screws $ (φ 4 × 16 mm).
Switching unit !
Velcro strips # carpet
1 Remove the backing from the velcro strips #
and attach it to the bottom of the switching
unit
!. Install the switching unit on the
carpet.