Kenwood KCA-S220A - Manual (Page 3)

• If you wish to adjust the cable length in accordance with the installation location of the switching unit, such as in the trunk
space, the disc changer extension cable may be used instead of the connection cable
"
.
• When a control unit belonging to Group A is used, you cannot use both TO CHANGER 2 terminal and AUX terminals at the
same time. For more details, see (page 5).
If you want to connect a stack CD changer
TO CHANGER 2 TO CHANGER 1 TO HEAD UNIT
SWITCH AUX OFF ON
IN AUX
To the external unit
Connection cable (supplied with the Disc changer)
Extension cable (CA-C2EX: Optional)
Stack CD changer
Disc changer
Control unit
Connection cable "
Switching unit !
(Rear side)
Switching unit !
(Front side)
Disc player
Connection cable (supplied with the stack CD changer)
TO HEAD UNIT
Changer control output
AUX IN
TO CHANGER 1 TO CHANGER 2
• Connect the stack CD changer to the terminal labelled TO CHANGER 2.
• Up to two disc changers can be connected.
• The O-N switch on the disc changer and the disc player should be set to "N". If you set it to "O", the equipment will not
function correctly.
• The total length of the cable between the units should not be more than 13 m (43 ft).
Control unit KCA-S220A Stack CD Changer Disc Player
Not more than 13 m (43 ft)
• If the voltage is low and the internal temperature of the switching unit is low, switching may fail to work properly in some
cases.
• The AUX switch on the stack CD changer should be switched "OFF" before using the equipment. The AUX terminal on the
KCA-S220A switching unit is the one that should be used.
English 3