Krups Orchestro 889 User Manual

Page 24

Appliance warning signals, possible causes and remedies

Warning signals

Causes

Remedies

Indicators glow

Indicator glows

Indicators blink

Indicator blinks

■ The appliance is in readiness to

produce steam

■ Water tank not correctly inserted

or removed during the espresso
or coffee preparation

■ Steam has just been produced

■ Selector knob for steam/hot water

in the incorrect position

■ 5000 lots of espresso or coffee

have been prepared

■ Too little water in the water tank

■ The float is defective or stuck

■ Spent coffee holder full

■ Drawer inserted too soon after

emptying

■ “Empty spent coffee holder”

indicator appears too soon

■ Drawer is not correctly inserted

■ Appliance too cold (under 10¡C)

■ Various causes

■ Actuate the steam key

■ Insert water tank correctly and

fill the heating system

■ Cool down the appliance from

steam to the espresso-/coffee tem-
perature or fill the heating system.

■ Turn the selector knob for steam/

hot water to the correct position

■ Switch off the indicator or let

KRUPS Service Unit carry out
maintenance

■ Add further water to the tank

■ Rinse out the tank and, if

necessary, remove lime-scale

■ Empty the spent coffee holder

■ Wait 10 seconds and then insert

■ Empty the spent coffee holder

when the appliance is switched off

■ Insert the drawer correctly

■ Allow the appliance to stand for

about an hour at room
temperature

■ Switch off the appliance, pull

out the mains plug and switch
on again after an hour

■ Let KRUPS Service Unit check

the appliance

Indicators blink

alternate