Kodak XBS444 - Manual (Page 39)

REFERENCE
39
Troubleshooting
Symptom
No power.
The power is on, but
the DVD+Hi-Fi VCR
does not work.
No picture.
No sound.
The playback picture is
poor.
The DVD+Hi-Fi VCR
does not start playback.
The remote control
does not work properly.
Cause
The power cord is disconnected.
No disc is inserted.
No tape is inserted.
The TV is not set to receive DVD+Hi-Fi
VCR signal output.
TV/VCR mode for DVD+Hi-Fi VCR is
set to TV.
The video cable is not connected
securely.
The connected TV power is turned off.
The Digital Audio Output is set to the
wrong position.
The disc is dirty.
Tape heads are dirty.
Tape is a rental or was recorded on
another VCR.
No disc is inserted.
No tape is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the guide.
The disc is dirty.
The remote control is not pointed at the
remote sensor of the DVD+Hi-Fi VCR.
The remote control is too far from the
DVD+Hi-Fi VCR.
There is an obstacle in the path of the
remote control and the DVD+Hi-Fi VCR.
The batteries in the remote control are
exhausted.
This remote control uses the same
buttons for VCR and DVD functions
(ex. PLAY).
Correction
Plug the power cord into the wall outlet
securely.
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
Select the appropriate video input mode
on the TV so the picture from the
DVD+Hi-Fi VCR appears on the TV
screen.
Press the TV/VCR button on the remote
control repeatedly to choose VCR
mode. TV indicator disappears from the
display window.
Connect the video cable securely.
Turn on the TV.
Set the Digital Audio Output to the
correct position, then turn on the
DVD+Hi-Fi VCR again by pressing
POWER.
Clean the disc.
Clean video heads.
Use CH/TRK ( v / V ) for manual tracking
adjustment while tape is playing.
Insert a disc or tape. (Check that the
disc or tape indicator in the display
window is lit.)
Insert a playable disc. (Check the disc
type, color system, and Regional code.)
Place the disc with the playback side down.
Place the disc on the disc tray correctly
inside the guide.
Clean the disc.
Point the remote control at the remote
sensor of the DVD+Hi-Fi VCR.
Operate the remote control within 23 ft
(7 m).
Remove the obstacle.
Replace the batteries with new ones.
When using a VCR tape, first press the
VCR button. When using a DVD, first
press the DVD button.
Check the following guide for the possible cause of a problem before contacting service.