Kenwood DNX5240BT - Manual (Page 16)

16
DNX5240/DNX5240BT GPS Navigation Instruction Manual
The Map and Other Tools
Turn List
The Turn List displays a list of turn-by-turn
instructions for your entire route, as well as arrival
information.
While navigating a route, touch the text bar on
the map page to open the Turn List. Or, from the
Menu page, touch
Tools > Turn List .
1 Direction of this turn
2 Distance to this turn
3 Turn directions
• Touch View All to see all the turns on the route. Touch
and to scroll through the list.
• Touch a turn to see the turn on a map (the Next Turn
page).
• Touch and to scroll through all the turns on
the route. Touch and to zoom in and out of the
turn on the map.
GPS Info Page
From the Menu page, touch the signal strength
bars in the upper left corner to view the GPS Info
page. Or, from the Menu page, touch
Tools > GPS
Info .
1 Sky view
2 Satellite signal-strength bars
The sky view shows the satellites you are
receiving. The satellite signal-strength bars
indicate the strength of each satellite you are
receiving. A solid bar indicates the GPS satellite is
ready for use.
GPS Settings Settings
From the Menu page, touch Settings > General
> GPS . You can also access the GPS Settings by
touching the GPS Settings button on the GPS
Info page.
• Simulator Mode—touch Off to turn the GPS receiver
off.
• Set Position—set your position, if Use Indoors is
enabled. Select your location on the map and touch OK .
• WAAS/EGNOS—disable and enable WAAS/EGNOS.
WAAS and EGNOS are systems of satellites and ground
stations that provide GPS signal corrections, giving you
even better position accuracy. To learn about WAAS and
EGNOS, visit
www.garmin.com/aboutGPS/waas.html .
1
2
1
2
1
2
3
Next Turn Page