Kunz C60K - Manual (Page 14)

For Model E60B: -
See Figure 10.
nuts on the spring loaded idler adjuster bolt until the length
of the spring is between 2-1/4” and 2-3/8”. This model comes with a belt brake when the clutch
ectly, the
blades will still spin even though the clutch may be in the disengaged position.
th Loosen the bolt on the top of the brake
e the brake stud in the slot until there is about 1/2” of clearance between the belt and
ing or overbraking may occur.
If overbraking occurs premature belt failure could occur and possible fire due to
With the clutch engaged, adjust the
is disengaged. This is a safety feature to stop the blades from turning after the clutch is
disengaged. To ensure that the brake works properly the spring length must be set correctly.
With the clutch disengaged make sure the spring length is no more then 2-3/4”.
The brake stud must be adjusted. If the brake stud is not adjusted corr
Always shut mower engine off before servicing.
e adjust brake place clutch in the engaged position. To
stud. Slid
the brake stud. Tighten the bolt at the top of the brake stud.
If brake stud is not set in correct position underbrak
overheating.
Figure 10: Belt Pattern and Spring Adjustment (Model E60B)
Front
Clutch Arm
Engine
Clutch Engagement
Brake Stud
1/2” With Clutch Engaged
0” With Clutch Disengaged
Clutch Engaged Spring
Length 2-1/4” to 2-3/8”
Clutch Disengaged
Spring Length no greater
than 2-3/4”
13