Kodak 5500 - Manual (Page 69)

3-48 A-61074 April 1997
Maximum code height Maximum code height defines the maximum bar code height
allowed. This definition is required only when the Codes Per
Document option is defined as
All Codes Decoded.
The default for all modes is 1 inch / 25.400 mm.
The options are:
— Within the range of 0.375 inches / 9.525 mm to 3.000 inches /
76.200 mm.
•
Select Maximum Code Height from the Bar Code Reader menu.
Single
6006
3111
Supprs
FthenR
None
Off
Off
NA NA Index Format
IA Field Width
Level Rules
IA Display Format
Adjoining IA
Batching
Length Monitor
Skew Monitor
Footswitch Patch Reader
COIN2 Port Select
OCR
Bar Code Reader
Printr Controller
Front Printer
Rear Printer
Mode Name
Overrides Off
n/a
n/a
Off
Supprs
Off
Off
MODE0
No Sav
Save & End Session
Save & Prev Menu
Don't Save & End Session
Don't Save & Prev Menu
Mode Number: 01 Mode Name: MODE01 Item #: 13.5
Mode Configuration
Enter Maximum Code Height
Range: 0.375 . . . 3.000
1.000 Use Arrow Keys to Set
Increase value by 0.125 inch or 3.175mm
Decrease value by 0.125 inch or 3.175mm
Bar Code Reader
On/Off
Bar Code Type
Codes Per Document
Minimum Code Length
Maximum Code Height
Scan Direction
Code Quality
Confirmation Tone
Bar Code Location
Previous Menu
•
Enter the desired bar code height allowed, using the numeric keys;
or
•
Use the arrow keys to increase or decrease the current maximum
bar code height to the desired bar code height allowed:
— The left arrow key will decrease the value in 0.125 inch or
3.175 mm increments.
— The right arrow key will increase the value in 0.125 inch or
3.175 mm increments.
•
Press Enter.
NOTE: The maximum code height also represents the minimum
height between bar codes when codes per document option
is defined as
All Codes Decoded. If the bar codes are closer
together than the measure of the maximum bar code height,
bar code reading is impaired.