Kenwood DDX6027 - Manual (Page 62)

Before Use
62 | English
Security Code Setup
You can set a security code to protect your receiver
system against theft.
• When the Security Code function is activated it cannot be
released.
Note, your Security Code is the 4 digit number entered in
your "Car Audio Passport" in this package.
1 Display the Security Code Setup screen
S e c u r i t y
If S e c u r i t y is not shown,
touch or to display it.
S e c u r i t y
O f f O n
S e t S e c u r i t y C o d e
S I
5 5
4
3
2
1
1 Returns to the Control screen of the previous
source.
2 Calls the Sound Effects Menu. (page 70)
3 Calls the Setup Menu.
4 Allows you to start security code registration.
5 Turns the SI function On or Off.
If turned "On", the burglar alarm lamp flashes
when the vehicle ignition is off. (
On)
• If you have already completed the code registration,
cannot touch S e t .
2
Start the security code registration
S e t
P a s s W o r d
E n t e r C a n c e l C l e a r
1 s t
1 2 3
4 5 6
7 8 9
0
2 3 4
1
1 Enters the numbers to your security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Registers your security code.
3 Enter a security code
0 — 9
Input a four-digit number.
4 Register your security code
E n t e r
5 Reenter the security code
Reenter the same security code as that you have
entered in Step 3 for confirmation.
• If you enter a different security code, the screen returns
to Step 3 (for the first code entry).
6 Register the security code again
E n t e r
Now, your security code is registered.
If you press the Reset button or if you disconnect
your receiver from the battery after the code
registration, you need to enter the registered
security code.
See below for details.