Kenwood KDC-4051UM - Manual (Page 18)

18
Installing the unit
Removing the unit
2
1
Connect the wiring harness to the unit. Other
wiring connection has been completed earlier.
(page 17)
Before attaching, make sure the direction of
the escutcheon is correct.
(Wider hooks on the top side.)
Dashboard of your car
T: Toyota cars
N: Nissan cars
1 Detach the faceplate.
2 Engage the catch pin on the removal tools into
the holes on both sides of the escutcheon, then
pull it out.
3 Insert the removal tools deeply into the slots on
each side, then follow the arrows instructions as
on the right.
Bend the appropriate tabs
to hold the mounting sleeve
firmly in place.
1 Remove the mounting sleeve and
escutcheon from the unit.
2 Align the holes in the unit (on both sides)
with the vehicle mounting bracket and
secure the unit with the supplied screws.
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
Unit Vehicle
A7 (Red)
Ignition wire
(Red)
A4 (Yellow)
Default wiring
Battery wire
(Yellow)
ISO connectors
Pin Color and function
A4
A5
A7
A8 Yellow
Blue/White
Red
Black Battery
Power control
Ignition (ACC)
Earth (ground) connection
B1 / B2
B3 / B4
B5 / B6
B7 / B8 Purple ª / Purple/black ·
Gray ª / Gray/black ·
White ª / White/black ·
Green ª / Green/black ·
Rear speaker (right)
Front speaker (right)
Front speaker (left)
Rear speaker (left)
Installing without using the mounting sleeve (Japanese car)
(KDC-U449/ KDC-U3049/ KDC-U349 only)
EN02-19_KDC-U449[M]f.indd 18 EN02-19_KDC-U449[M]f.indd 18 9/13/10 5:40:34 PM 9/13/10 5:40:34 PM