Keys Fitness ST-IB - Manual (Page 12)

12
Assembly
NOTE : Hand tighten bolts and nylon nuts until machine is fully assembled.
Step 12
Apply grease to the barrel of the M10X70mm bolt set (55). Next, attach the leg lever (18) to
the front leg (12) and secure using the bolt set (55). Make sure the barrel of the bolt set (55)
is inserted through both sides of the bracket on the front leg (12).
Note: Do not overtighten the bolt set; the leg lever must pivot easily.
18
12
55
Grease
Bracket
Figure 12
Step 13
Insert a pad tube (24) into either hole on the front leg (12). Slide a foam pad (23) onto each
end of the pad tube (24).
Insert a pad tube (24) into a hole on the leg lever (18). Slide a foam pad (23) onto each end
of the pad tube (24). Press a pad cap (68) into each end of the tube.
Note: It is recommend you use a rubber mallet to gently hammer the caps into place.
Repeat for other pad tube (24).
23
23
18
68
68
24
12
24
23
Figure 13