Kenwood KDC-D300 - Manual (Page 8)

— 8 —
English
Operations
Display Level Adjustment
You can adjust the spectrum analyzer level.
Selecting CD play source mode.
Press the DISP button for at least one second.
Press either the ¢ or 4 button on the centre unit.
Press the ¢ button:Level increased.
Press the 4 button:Level decreased.
(by 11 steps)
Ending the display level adjustment mode:
Press the DISP button.
3
2
1
Eject
A press of the 0 button stops the CD play and ejects the CD.
When you load a CD and eject it right away, the next time you try
to insert the CD may not load. In such a situation, take the CD
out for a moment and then reinsert it.
NOTE
0
Theft Deterrent Faceplate
The faceplate of the unit can be detached and taken with you,
helping to deter theft.
Removing Faceplate:
Press the release button and drop open the faceplate.
In its dropped condition, whilst drawing the faceplate to one
side, pull it to the front and remove it.
• If the controls remain untouched for a period of 5 minutes or
more after the panel has dropped open or been removed, the
disc will automatically stop playing. (A warning beep starts
sounding 30 seconds before play stops automatically.)
• The faceplate is a precision piece of equipment and can be
damaged by shocks or jolts. For that reason, keep the
faceplate in its special storage case whilst detached.
• Do not expose the faceplate or its storage case to direct
sunlight or excessive heat or humidity. Also avoid places
with too much dust or the possibility of water splashing.
NOTE
£
INTEGRATED QUAD
1 BIT D/A
CONVERTER KDC-D300 CD PLAYER
DIGITAL OPTIMUM
SERVO CONTROL 11BAND SPECTRUM ANALYZER 60 120 250 380 500 750 1k 2k 4k 8k 16k
DPAC
DISP
Release button