Kodak EASYSHARE D725 - Manual (Page 12)

7 www.kodak.com/go/support
Getting started
The following types of standard picture frames will not fit on your EASYSHARE Digital
Frame.
■ Frames that secure a photo by pressing it between two pieces of glass.
■ A deep frame that’s designed to hold 3-dimensional objects instead of photos.
■ Frames with inserts in which the insert holds the standard picture size.
■ Frames with a hinged or otherwise non-removable back.
■ Frames with a curved or uneven mounting surface.
■ Frames with a round, oval, or other non-rectangular mounting area.
■ Frames in which you slide the picture into one end.*
■ Handcrafted frames.*
* You may be able to use these frame types. Check for individual frame compatibility.
General attachment details
1 If the faceplate that was packaged with your frame is attached, remove it ( see
page 1 ).
2 Remove the back, backing material, and the glass from the standard picture frame.
Use CAUTION when handling the glass, the edges are sharp.
NOTE: You must remove the glass.
Store the original faceplate and contents of the standard picture frame in the box
that came with your digital frame. Keep for later use.
3 Place the standard picture frame face down on a protected flat surface, and place
the digital frame into the picture frame.
4 Attach the frames together according to the following directions. Keep any leftover
foam spacers for later use.
5 When attached, make sure the digital frame is secure within the picture frame and
can’t shift or move around.