Kenwood KAC-816 - Manual (Page 7)

7
POWER IN FUSE(20A)
BATT
GND
FUSE(20A)
P.CON(REMOTE)
SPEAKER OUTPUT
20
20
SPEAKER OUTPUT SERVO ΙΙ ∑ SERVO ΙΙ ∑
- +
■ Power and Speakers cable connection
Power control
(REMOTE) lead
terminal
• Connect the ground cable to a metal part of the car chassis that
acts as an electrical ground passing electricity to the battery‘s
negative - terminal. Do not turn the power on if the ground cable
is not connected.
• When installing two amplifiers, connect a power tune-up cable to
each of them while taking care not to exceed the cable capacity.
• The power cable should be thick enough to supply the required
current and connected directly from the battery.
NOTE
• If a buzzing noise is heard from the speakers when the engine is running,
connect a line noise filter (optional) to each of the battery cable.
• Do not allow the cord to directly contact the edge of the iron plate by using
Grommets.
Terminal cover
Fire wall
Grommets
Battery
Ground cable (Black) Battery cable (Yellow)
Round terminal (Large)
Power control cable
Power terminal
Pass battery and ground cables through supplied
terminal cover and connect to respective
terminals. After completing connections, fasten
terminal cover over terminal bracket.
Round terminal (Medium)
Round terminal (Small)
Speaker output cable terminal
Connect the speaker output
cables to these terminals.
Lead terminal
(Commercially
available part)
Speaker output
cable
To prevent fire caused by a
short in the wiring, connect
a fusible link or breaker
nearby the battery’s
positive terminal.
2WARNING
Subwoofer
Distribute the speaker cables and
sigma servo cables along the
same paths.