Knoll Systems HD225 - Manual (Page 9)

9
Displaying a video
image
Remove the lens cap.
Press the Power button on
the top of the projector or
the remote.
The fans start to run. When
the lamp comes on, the
startup screen is displayed.
It can take a minute for the
image to achieve full
brightness.
? No startup screen? Get help on page 11.
Plug in and turn on the video
device.
The video device’s image should appear on the projection screen. If it doesn’t, press the Source
button on the keypad or remote.
Adjust the height of the
projector by pressing the
release button to extend
the elevator foot. Rotate the
leveling foot, if necessary.
Position the projector the desired
distance from the screen at a 90-degree
angle to the screen. See 26 for a table
listing screen sizes and distances to the
screen.
Adjust the zoom or focus rings by
rotating them until the desired
image size and focus are produced.