Kodak CIS-201 User Manual
Page 9
Printer Conversion to KODAK EKTACOLOR Edge 8 and EKTACOLOR ROYAL VIII Papers
•
CIS-201
9
b. Type MOPC (Modify Paper Channel). Enter the
Paper Channel that you copied to in Step 3a.
c. Change the Paper Type to the Paper Number of the
new paper defined in Step 2.
d. Save the changes. (Enter Y when VALUES OK?
appears.)
4. Create a Film Channel.
a. Copy your current Film Channel to an unused Film
Channel (use the COFC command). Enter the
source channel and destination channel. Save the
changes. (Enter Y when VALUES OK? appears.)
b. Type MOFC (Modify Film Channel). Enter the
Film Channel that you copied to in Step 4a.
c. Change the Brand/Paper Type to the code number
of the new table created in Step 1.
d. Adjust the balance 0.000, 0.010, -0.040 to
compensate for the Agfa MSP densitometer.
e. Save the changes. (Enter Y when VALUES OK?
appears.)
5. Balance the paper.
a. Load a roll of EKTACOLOR Edge 8/ROYAL VIII
Paper into a magazine and install it in the printer.
b. Load the Paper Channel from Step 2 and the Film
Channel from Step 3, using the LOAD command.
c. Expose a test print by using the ETP (Expose Test
Print) command. Process the test print. Use the
ACC (Automatic Channel Calibration) command
and insert the test print when prompted. Allow the
recommended Paper Channel changes. Make
another test print and continue this step until no
changes are needed.
d. The balanced test print will appear cyan-green, and
will be approximately +0.12 cyan and –0.03 green
from neutral Status A. The Film Channel balance
change compensates for this bias.
e. Run a reel of test negatives to confirm that the new
paper has been correctly installed.
AGFA-Recommended Schwarzchild Coefficients for KODAK EKTACOLOR Edge 8/ROYAL VIII Papers
AGFA Recommendations for Printing on KODAK EKTACOLOR Edge 8/ROYAL VIII Papers
MSP / MSC
MSCs Without
Loqik 4
MSCs With
Loqik 4
Blue
Green
Red
Blue
Green Red Blue
Green Red
25ms
0.016
0.001
0.008
50ms
0.006
-0.002
0.002
100ms
0.000
0.000
0.000
13
-9
-1
13
-9
-1
200ms
-0.008
0.004
0.001
5
-6
0
5
-6
0
400ms
-0.013
0.009
0.001
0
0
0
0
0
0
800ms
-0.016
0.016
0.002
-3
6
1
-3
6
1
1600ms
-0.016
0.022
0.004
-3
13
3
-3
13
3
3200ms
-0.021
0.032
0.005
-7
23
4
-7
23
4
Gamma 1/2/3
1.8
2.4
2.7
1.8
2.4
2.7
1.8
2.4
2.7
Type Measuring Filter for
MSP
MSC/PSP8
MSC 101
7660/261
8501/147
8506/213
MASK Value—MSP Only
(Command MOTC)
Blue
Green
Red
Mask
0.901
0.720
0.340
Under
1.322
1.060
0.718
Normal
1.778
1.435
1.128
Over
2.623
2.201
1.913