Kenwood DDX3048 - Manual (Page 58)

58 DDX418/DDX4048BT/DDX318/DDX3048
Symptom Remedy/Cause
iP
od/iPhone
Sound is distorted. Deactivate the equalizer either on this unit or the
iPod/iPhone.
A lot of noise is generated. Turn off (uncheck) the “VoiceOver” feature of the
iPod. For details, visit .
No operations are available
when playing back a track
containing Artwork. Operate the unit after the Artwork is loaded. (☞
page 20)
USB
“Reading...” keeps flashing on the
screen. Turn off the power and on again.
While playing a track, sound is
sometimes interrupted. The tracks are not properly copied into the USB
device. Copy tracks again, and try again.
Bluetooth (only f
or DD
X418/DD
X4048B
T
)
Phone sound quality is poor. • Reduce the distance between the unit and the
Bluetooth mobile phone.
• Move the car to place where you can get a better
signal reception.
The sound is interrupted or
skipped while using a Bluetooth
audio player. • Reduce the distance between the unit and the
Bluetooth audio player.
• Disconnect the device connected for Bluetooth
phone.
• Turn off, then turn on the unit.
• (When the sound is not yet restored) connect the
player again.
The connected audio player
cannot be controlled. Check whether the connected audio player
supports AVRCP (Audio Video Remote Control
Profile).
Bluetooth device does not
detect the unit. • Check whether the Bluetooth adapter (KS-UBT1)
is inserted correctly.
• Search from the Bluetooth device again.
The unit does not make pairing
with the Bluetooth device. Enter the same PIN code for both the unit and
target device. If the PIN code of the device is not
indicated on its instructions, try “0000” or “1234.”
Echo or noise occurs. Adjust the microphone unit position.
The unit does not respond when
you try to copy the phone book
to the unit. You may have tried to copy the same entries (as
stored) to the unit.
EN_DDX_K.indb 58 EN_DDX_K.indb 58 10/12/20 18:36 10/12/20 18:36