Rear panel – Kustom GROOVE 310C User Manual

Page 7

{

}

Circuit Breaker:

Power Cord

Speaker Output

Ground Lift Switch

Direct Output Jack

Pre EQ / Post EQ Switch:

Tuner Out Jack:

Effects Send Jack

Effects Return Jack

Footswitch Jack:

This circuit breaker will trip when too much

current is applied to the amplifier. To reset: Turn
off

, press circuit breaker button,

and turn the

on. Note: If the

Circuit Breaker trips repeatedly when AC power
is applied, take the amplifier to an authorized
service center for repair.

This supplies AC power to the amplifier. If the

cord becomes damaged, take the amplifier to an
authorized service center for repair.

This jack is used to connect the amplifier to

internal speakers, or an external speaker cabinet,
using a heavy duty Speakon speaker cable.

To prevent overheating and possible loss of

signal, do not connect a load lower than 2 ohms.
(To connect a cable: Align tab on speaker cable
connector slot. Insert and twist one quarter turn
clockwise to lock. To remove a cable: Pull back
release button on cable connector, twist connecter
counter clockwise one quarter turn, and pull out
connecter.)

Activating this switch removes the ground

connection on the

Removing the ground connection will eliminate
ground related signal hum and noise.

This is a line level output used to connect the

amplifier to another device, such as a mixer or
recorder.

When set to Pre EQ, the

signal will be unaltered by the EQ sections of the
preamp. When set to Post EQ, the

signal will reflect the entire sound (including

EQ settings) of the preamp.

The

and

have no

effect on the

signal.

Use this jack to connect to a tuner or other line level

device. This jack is always active and is a pre-gain
output.

Use this jack to connect to the input of an external

effects processor. This jack can also be used as a
preamp out.

Use this jack to connect to the output of an external

effects processor. This jack can also be used as a
power amp in.

This 3-conductor 1/4” jack may be used for
connecting a footswitch to the amplifier
(Footswitch model KAC-GFS100 is included with
the amplifier). The footswitch will then control the
Mute and Solo features.

Power Switch

Note:

Direct Output Jack

Direct Output

Jack

Note:

Master

Volume Control

Solo On/Off Button

Direct Output Jack

Rear Panel

DIRECT OUTPUT

EFFECTS LOOP

SEND

RETURN

FOOTSWITCH

TUNER OUT

GROUND

LIFT

MADE IN CHINA

SERIAL NUMBER

MODEL: GROOVE 600

8A/250V

DESIGNED IN USA

CAUTION

CHASSIS SURFACE HOT

ATTENTION

SUPERFICE DE CHASSIS CHAUDE

KUSTOM INC

CINCINNATI,OHIO USA

SPEAKER OUTPUT

600W RMS 3 Ohm

120V

60Hz 1500W