Kustom GROOVE 310C - Manual (Page 6)

Front Panel
a
c
d
e
f
g
h
i
j
Guitar Input Jack:
Gain Control:
Clip Indicator:
Signal Indicator
Mute Indicator
Mute On/Off Button
Bass Control
Mid Control
High Control:
T
Adjust clockwise to increase the amount of preamp
volume. When set too low, the will
not light.
Indicates when the input signal has reached
maximum level. The
is the only control on the amplifier that has an effect
on this. If the switch is set to Active and the Clip
Indicator still lights, lower the output of your
instrument to correct.
Indicates when sufficient signal is applied to the
preamp. Adjusting the will affect this
This indicator will light when the preamp is muted.
This can be done by either pressing the
on the front panel or by pressing
Mute on the footswitch. The
will still be active when this is lit
When this switch is active the preamp will be muted.
However, the is always active.
Controls the amount of low frequency in the signal.
The changes the center
frequency for this control. (See )
Controls the amount of mid frequency in the signal.
The changes the center
Frequency for this control. (See )
Controls the amount of high frequency in the signal.
The changes the center
frequency of this control. (See )
Signal Indicator
Note: Active / Passive Switch
Gain Control
Mute
On/Off Button
Note: Tuner Out
Jack
Tuner Out Jack
Note:
Normal / Sub Switch
Normal / Shift Switch
Normal / Define Switch
When using the footswitch, this button will be
disabled.
.
Controls the overall output of the amplifier.
Turns AC power on and off.
Indicates when the is pressed.
This will also light when Solo on the footswitch is
pressed.
When this is active, the signal to the power amp will
be boosted by 6dB.
When using the
footswitch, this button will be disabled.
Indicates when AC power is applied to the amplifier.
:
:
:
:
:
Normal / Sub Switch:
Normal / Shift Switch:
Normal / Define:
Graphic Equalizer Section:
Master Volume Control:
Power Switch:
Solo Indicator:
Solo On/Off Button:
Power Jewel:
k
l
m
k
l
m
n
o
p
q
r
s
Solo On/Off Button
Note:
his is a 1/4" 2-conductor input jack for plugging in
your instrument. It is intended for bass guitar but will
accept other instruments as well
Set this switch to Active when using an active bass
guitar. Setting to Active will lower the input gain by
12 dB.
.
.
When this switch is set to Normal, the
frequency is centered at 100Hz. When this switch is
set to Sub, the
frequency is centered at
50Hz.
When this switch is set to Normal, the
frequency is centered at 800Hz. When this switch is
set to Shift, the
frequency is centered
at 400Hz.
When this switch is set to Normal, the
frequency is centered at 3KHz. When this switch is
set to Define, the
frequency is
centered at 5KHz
This 9-band graphic equalizer is used to finely adjust
the sound to taste.
.
b
Active/Passive Switch
Bass Control
Bass Control
Mid Control
Bass Control
High Control
High Control
6
GAIN
BASS MID HIGH MASTER GUITAR
INPUT
MUTE
ACTIVE
PASSIVE
MUTE
ON/OFF SIG
CLIP
SUB
NORMAL
SHIFT
NORMAL
DEFINE
NORMAL
-12
0
-6
+6
+12
100 200 400 800 3.2K 1.6K 30 50 6.4K
SOLO ON/OFF
SOLO
POWER
ON
OFF