beautypg.com

Connecting the receiver – Kompernass WELLTECH WT 40458 User Manual

Page 9

background image

- 7 -

Note:

Observe the colour coding:

• "White" CINCH plug to white

CINCH socket

• "Red" CINCH plug to red CINCH

socket

• "Yellow“ CINCH plug to yellow

CINCH socket.

Connect the SCART double adapter

(1() to the AV socket of your transmis-

sion source (e.g. SAT receiver).

Adjusting the transmitter signals

The video transmitter (e) is designed

so that a sufficiently high output voltage

for faultless operation is supplied when

simultaneously connected to a source

(computer, DVD player, satellite receiver)

together with other devices via the in-

cluded adapter. The local TV switch (i) in

the connection panel is then in the "YES"

position.

If only the video transmitter (e) is con-

nected to the video source, without

another device such as a DVD player/

VCR), image disruptions may occur for

some device combinations. In this case,

set the slider switch (i) to "NO" (= no

additional device connected). This lowers

the signal power so that the video and

sound are transmitted without distortions.

Note:

If the AV socket of your transmission

source is already in use, use the out-

put of the SCART double adapter (1()

for the original connection . Connect

the infrared cable (2#) to the infrared

connection socket (u) of the trans-

mitter. Tape one of the self-adhesive

transmission diodes of the infrared

cable (2#) to the infrared receiver of

your transmission source.

Note:

Avoid attaching the transmission

diode directly to the infrared receiver

of your transmission source. Direct

remote control commands can now

be issued as usual.

Note:

Use the remaining transmission diodes

for additional devices. You can then

connect these devices with the trans-

mission source. Connect the transmitter

(e) with a connector power pack (2@)

using the 6 V DC connection socket (t).

Connect the connector power pack (2@)

with a 230 V~/ 50 Hz wall socket.
Use the "ON/OFF" switch (r), which

is located on the side, to switch on the

transmitter (e). Rotate the antenna for

the remote control signals (q) upward.

Orient the audio/video transmitter an-

tenna (a).

Important!

The unlabelled side must point in the

direction of the receiver (f).

Switch on your transmission source. If

necessary, start playback on your trans-

mission source (e.g. SAT receiver/set top

box, DVD/CD player, VCR, PC etc.).

Connecting the receiver

Connect the other CINCH (RCA) cable

(2!) to the receiver (f) and the SCART-

CINCH adapter (2)).

Note:

Be sure to match the colours correctly.