beautypg.com

Improving the transmission quality, Transmitter connection examples – Kompernass WELLTECH WT 40458 User Manual

Page 10

background image

- 8 -

Plug the SCART-CINCH adapter (2)) into

the SCART socket of your TV. Connect

the receiver to the other connector power

pack using the 6 V DC connection socket

(j).
Connect the connector power pack

(2@) with a 230V~/50 Hz wall socket.

Use the "ON/OFF" switch (g), which

is located on the side, to switch on the

receiver (f).

Important!

The transmission channel

switch (o) and the reception

channel switch (l) must be

set to the same channel.

Otherwise radio transmission

is not possible.

Rotate the antenna for transmission of the

remote control signals (s) upward.

Orient the audio/video reception an-

tenna (h) for the best image and sound

quality. The unlabelled side of the antenna

should point in the direction of the trans-

mitter (e).

Important!

If necessary, try positioning the receiver

(f) in a different location to avoid

interference effects.

Switch on your TV.

You can use the following connection

options on your TV.

The AV socket (SCART/CINCH

connection)

Point the remote control of the transmission

source at the infrared receiver (d) of the

receiver (f). The commands are sent to

your transmission source.

Improving the transmission quality

You can try the following measures to im-

prove the quality in event of transmission

disruptions:

Orient the audio/video transmitter

antenna or reception antenna (a, h)

differently.

Change the location of the transmitter

(e) and/or the receiver (f).

Change the position of the transmission

diodes of the infrared cable (2#) on

the infrared receiver of the transmission

source. The remote control signal quality

is improved.

Try a different channel, either A, B, C

or D.

Depending on the image source (DVD

player, SAT receiver, VCR, etc.) and

the image contents (with large bright

areas), overpowered video signals

may occur in combination with certain

TVs. These appear as distorted images.

In this case, you can use the local TV

switch (i) to adjust the transmission

level and eliminate the distortions.

Transmitter connection examples

Note:

In general:

You can transmit signals from

any

device that outputs a sound and/or

video signal on an appropriate

connection:

• CD player

• DVD player

• VCR

• Television

• SAT receiver/set top box

• Video camera

• PC graphics card