Kenwood D-R350 - Manual (Page 4)

D-R350 (En)
4
System connections
Caution:
Do not plug in the power lead until all connections are com-
pleted.
Malfunction of microcomputer
If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microcomputer referring to “In case of difficulty”.
∞
Make connections as shown below.
When connecting the related system components, refer also to the
instruction manuals of the related components.
Caution regarding placement
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer
dimensions including projections) equal to, or greater than, shown below.
Left and right panels: 10 cm Rear panel: 10 cm
1. Connect all cords firmly. If connections are loose there could be loss of sound or noise produced.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Notes Notes
* The above illustration is simply an example.
The actual connected equipment may vary depending on the sales area.
L
R
LINE OUTPUT DIGITAL OUTPUT
OPTICAL
AC 110-
120V AC 220-
240V
COAXIAL
SISTEM
CONTROL
TEXT
L
R
CD
SYSTEM
CONTROL
AV CONTROL CERTER
Digital component (MD, DAT, etc.)
DIGITAL INPUT
(COAXIAL)
(OPTICAL)
Commercially-available
optical fiber cable
75 Ω coaxial cable with RCA PIN.
(Commercially-available)
To AC outlet
Audio cord
System control cord
Remove the protection cap when using
the DIGITAL OUTPUT (OPTICAL) jack.
AV CONTROL CENTER (sold separately)
or receiver (sold separately)
To wall AC outlet