Kenwood D-R350 - Manual (Page 16)

D-R350 (En)
16
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a
desired order. (Up to 32 tracks)
÷ Load a disc in the CD player.
÷ Set the INPUT SELECTOR to ”CD“ on the
connected device such as AV CONTROL
CENTER or receiver.
Press so that the “PGM” indicator lights.
1
Preparation
GRC operation RC operation
: Keys and control used in the operations described on this page.
P.MODE
Do this operation in the stop mode.
2
GRC operation RC operation
Program desired tracks.
In the case of a CD-TEXT disc, the track’s title is scrolled on the display.
1
Select the disk.
+10
5 4 3 2 1
0 9 8 7 6
2
Select the desired track No.
Go to step
2
within 8 seconds.
Press the numeric keys as shown below....
To enter track No. 25:
005
RC operation
Go to step
3
within 8 seconds.
3
Set the entry.
4
Repeat steps
1
,
2
and
3
above.
3
GRC operation RC operation
6
PGM
Mode
P.mode
ENTER
ENTER
ENTER
Disc Skip
ENTER
1 2 3
4 5 6
7 8 9
0 +10
ENTER
P.mode
ENTER
ENTER
G P 0 M 1 I D C S ?
Blinks.
G P 0 M 1 1 D T O N ? . ?
G P 0 M 1 1 D T O N 2 . 5
«
G P 0 M 1 B A D C F E H G
In the case of a CD-TEXT disc, the disc title is scrolled on the display.
REPEAT
DISC SKIP
P.MODE
Press the ENTER key after selecting each numeric icon.
#
GRC operation
÷ Tracks can also be selected by pressing the 4 or ¢ key.
÷ Up to 32 tracks can be programmed. When “FULL” is displayed, no
more tracks can be programmed.
÷ If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
G P 0 M 1 1 D T O N 2 . 5
÷ When the 4 or ¢ key is pressed during playback, the track will be
skipped in the direction of the pressed button.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
To stop playback
Press the
7 key.
÷ The programmed contents remain in memory.
GRC operation : Complete the procedure in “Basic Operations
for the Graphical Remote Control Unit (GRC)”
90
Start playback.