Krell Industries Evolution One - Manual (Page 23)

19
SECTION
FOUR
Connecting the Evolution One
to Your System
This section describes Evolution One amplifier connections and outlines remote
control options. Each Evolution One has a CAST 4-pin connector, a balanced input
via an XLR connector, a 12 Volt trigger In/Out connection, and an RC-5 input on
the back panel.
CAST Connections
Krell recommends using its proprietary Krell CAST system for unparalleled sonic
performance for connections between an Evolution One amplifier and other
CAST-equipped components. Krell CAST uses flexible interconnecting cables that
can be drawn through tight spaces and concealed.
Balanced Connections
Evolution One amplifiers also offer balanced connections. Balanced connections
not only can minimize sonic loss but also are immune to induced noise, especially
for installations using long cables.
Cable Connection Steps
The following steps describe how to connect cables to an Evolution One
amplifier:
1. Turn off all power sources and components before connecting inputs and out-
puts.
2. Neatly organize wiring between to and from the amplifier and all components.
Separate AC wires from audio cables to prevent hum or other unwanted noise
from being introduced into the system.
continued