beautypg.com

Assembly – Kenmore 125.15885800 User Manual

Page 7

background image

7

ASSEMBLY

Choose a good, cleared assembly area and
get a friend to help you put your smoker
together. Lay cardboard down to protect
smoker finish and assembly area.

CAUTION: Some parts may contain

sharp edges. Wear protective
gloves if necessary.

Note: With the help of a friend, turn the

smoker cabinet upside down.

Step 1

For each leg, line up the holes and insert three
1/4-20 X 5/8” bolts, nuts are pre-welded to the
cabinet. Securely tighten the bolts.

Note: With the help of a friend, turn the

smoker body to its upright position. Try
to minimize stress on legs.

Step 2

Install air vent tube by lining up the holes with
the back panel holes on the inside of smoker
cabinet. Insert two 10-24 X 1” bolts from the
outside of the cabinet.

Step 3

From inside the cabinet, slide washers onto
bolts and thread 10-24 flange nuts onto bolts.
Securely tighten nuts.

Note: Line up the side handle with the

corresponding holes on the side of the
cabinet as shown.

Step 4

Attach side handles by using two
10-24 X 5/8” bolts through handle loops.
Securely tighten. Repeat for other handle.