Kidde I9070 - Manual (Page 12)

USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE
ALARM REPLACEMENT.
Note: Replacement batteries are available where you purchased your
alarm.
CARBON-ZINC TYPE: EVEREADY 1222; GOLD PEAK 1604P OR
1604S
ALKALINE TYPE: ENERGIZER 522; DURACELL MN1604 OR
MX1604; GOLD PEAK 1604A PANASONIC
6AM6, 6AM-6, 6AM-6PI, 6AM6X, AND 6LR61 (GA)
LITHIUM TYPE: ULTRALIFE U9VL-J
NOTE: WEEKLY TESTING IS REQUIRED!
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION
INSTRUCTIONS PRINTED ON THE BACK OF THE ALARM AND USE
ONLY THE BATTERIES SPECIFIED. USE OF DIFFERENT BATTERIES
MAY HAVE A DETRIMENTAL EFFECT ON THE SMOKE ALARM
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as outlined in
the beginning of this section. You can clean the interior of your alarm
(sensing chamber) by using compressed air or a vacuum cleaner hose
and blowing or vacuuming through the openings around the perimeter
of the alarm. The outside of the alarm can be wiped with a damp cloth.
After cleaning, reinstall your alarm and test your alarm by using the test
button. If cleaning does not restore the alarm to normal operation the
alarm should be replaced.
6. Maintenance