Kenwood DPF-J9030 - Manual (Page 7)

7
Connecting to a Receiver or Amplifier
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
To Connect the Changer to a Kenwood Receiver
1. Unplug the receiver from the wall outlet or power strip.
2. Connect the audio cable from output A on the CD changer to the receiver as shown to the left. If you are connecting
the CD changer to a receiver that supports Dual-Zone/Dual-Source listening (such as the VR-4900/KRF-V9993D
shown in the illustration), connect audio cables for both outputs A and B to the appropriate jacks on the receiver.
3. Connect an optional optical digital cable from the changer to the receiver as shown to the left. If your receiver does
not support digital output, skip this step.
If you do not connect a digital cable or if your receiver does not support digital output and DTS decoding, DTS discs
do not play on your changer.
4. Connect the system control cable from the changer to the receiver jack as shown to the left. If your receiver has the
SL16/XS8 mode select switch, set the connected receiver to the [SL16] mode. If you are connecting more than one
Kenwood device with a system control cable, see “What if I Have Several Kenwood Devices ?” for more information.
8
5. Connect the SL16 text cable (Communication cable) from the changer to the receiver’s jack as shown to the left.
6. Plug the changer’s power cable into a wall outlet or power strip.
7. Plug the receiver’s power cord back into a wall outlet or power strip.
To Connect the Changer to a Non-Kenwood Receiver or Preamplifier
To Connect the Digital Output Directly to a Digital Recorder (MD, DAT, etc.)
1. Unplug the digital recorder from the wall outlet or power strip.
2. Connect the digital cable from the changer to the recorder.
3. Plug the changer’s power cable into a wall outlet or power strip.
4. Plug the recorder’s power cable back into a wall outlet or power strip.
If operation is not possible or erroneous display appears even though all connections have been made properly, reset the microcomputer
referring to “In case of difficulty”.
q
Malfunction of microcomputer
1. Unplug the receiver or preamplifier from the wall outlet or power strip.
2. Connect the audio cable(s) from output A on the CD changer to the receiver or preamplifier as shown to the left.
3. Connect an optional optical digital cable from the changer to the receiver or preamplifier as shown to the left. If your
receiver does not support digital output and DTS decoding, skip this step. If you do not connect a digital cable or if your
receiver does not support digital output, DTS discs do not play on your changer.
4. Plug the changer’s power cable into a wall outlet or power strip.
5. Plug the receiver’s power cable back into a wall outlet or power strip.
If your receiver does not support digital output, but you want to record discs to a digital format, you can connect the CD changer
directly to a digital recording device, such as an MD or DAT recorder.