Kenwood LZ-7500 - Manual (Page 6)

6 - English
Operation
Setting the AV Output Mode
Touch Setting
[ 7NORMAL] Picture/sound with monitor picture
[ 7NAV] Navigation Sound
[ 7VD1] Picture/sound from terminal
[ 7VD2] Picture/sound from terminal
Touch Sensor Tone
Setting the operation check sound (beep sound)
ON/OFF.
Touch Setting
[ 7ON] Touch sensor tone is turned on
[ 7OFF] Touch sensor tone is turned off
Return to the System Setup Screen -1
Touch the [ 2 ] button.
Exit the System Setup Screen
Touch the [RTN] button.
Return to the setup menu screen.
RTN S Y S E M T
A V - O U T
V D 1 V D 2
B E E P
N A V N O R M
O N O F F
R E S E T C A N C E L
T O U C H P A N E L A D J U S T
P l e a s e T o u c h
t h e C e t e r o f
t h e B u t o n i n
L e f t - B o t t o m C o r n e r
n
t t h e
Touch Panel Adjustment
The touch panel can be adjusted if the position
touched and the operation performed do not match.
Accurately touch the mark at the lower left.
Accurately touch the mark at the upper right.
When the mark at the upper right is touched, the
adjustment is completed and the system setup menu
screen reappears.
• If the [ CANCEL ] button is touched without touching the
button at the lower left, the adjustment is cancelled and the
screen that was set before switching to the system setup
menu reappears.
• If the [ CANCEL ] button is touched after touching the button
at the lower left, the button at the lower left reappears.
• If the [ RESET ] button is touched, the settings are reset to
the factory defaults and the setup menu screen reappears.
2
1
System Setup Screen-2
Touch Panel Adjustment Screen
LZ-7500(W)_EFG_01 02.2.15 10:14 AM Page 6