Kenwood LZ-7500 - Manual (Page 5)

Setting the Navigation Mode
Touch Setting
[ 7RGB] It becomes the RGB-image mode setting.
Operate the V.SEL button when the RGB-
image from the navigation unit connected to
[ 7AV-IN1] It becomes the composite--image mode
setting. Operate the V.SEL button when the
composite-image from the navigation unit
connected to terminal is shown on
the monitor.
[ 7OFF] It becomes the off mode setting. Use this
setting when there’s nothing connected to
the
Setting the AV IN-1 Mode
Touch Setting
[ 7AV-IN1] It becomes the video mode setting. Operate
the V.SEL button when the image from the
device connected to terminal is
shown on the monitor.
[ 7OFF] It becomes the OFF mode setting.Use this
setting when there’s nothing connected to
the terminal.
If you select "AV-IN 1", "NAV" setting is changed to "RGB".
Setting the AV IN-2 Mode
Touch Setting
[ 7AV-IN2] It becomes the video mode setting. Operate
the V.SEL button when the image from the
device connected to terminal is
shown on the monitor.
[ 7OFF] It becomes the off mode setting.Use this
setting when there’s nothing connected to
the terminal.
English - 5
Setting the Camera Mode
Touch Setting
[ 7AUTO] It becomes the Rear view camera mode
setting. When the reverse sensor cable is
powered up, the monitor image is switched
to the image of the device connected to the
terminal.
[ 7VD] It becomes the video mode setting. Operate
the V.SEL button when the image from the
device connected to
terminal is shown on the monitor.
[ 7OFF] It becomes the off mode setting.Use this
setting when there’s nothing connected to
the terminal.
Switching to the System Setup Screen -2
Touch the [ 3 ] button.
Exit the System Setup Screen
Touch the [RTN] button.
Return to the setup menu screen.
RTN S Y S E M T
V D 2
A V - I N 2 O F F
A V - I N 1 O F F
N A V
V D 1
A V - I N 1 O F F
C V I D E O A M E A R /
A U T O V D
R G B
O F F
System Setup Screen-1
LZ-7500(W)_EFG_01 02.2.15 10:14 AM Page 5