Kodak DS1000 - Manual (Page 2)

KODAK PROFESSIONAL EI Photographic Satin Print Paper / 160 g
Revised 5-00
Printed in U.S.A.
KODAK PROFESSIONAL EI
Photographic Satin Print Paper / 160 g
KODAK Publication No. E-2473
FINISHING
Lamination
Compatible with heat-assisted and pressure-sensitive laminate materials. Use of heat-activated laminates with Encad 700/GS and
GS+ inks, Epson 9000 Dye and Mutoh 4100 Dye ink is not recommended.
It is important that your print be dry before laminating and that you laminate within 24 hours. For best results, use inkjet-specific
laminate products and follow laminate, manufacturer's instructions as a starting point. Since lamination performance varies as a
function of materials, technique and environmental conditions, it is important to run tests to determine the best methods for your
setup. Cleanliness of prints and work area is critical to avoid defects in lamination.
For increased durability, choose a laminate with UV protection and encapsulate with a 1/4-1/2" (6.5-13 mm) seal around the
print edges to prevent moisture and other airborne pollutants from reaching the image. Heavier weight papers may require a wider
edge seal.
Mounting
Prints can be mounted (laminated or not) to a variety of materials, including poster board, foam board, Sintra, Lexan and more.
Use inkjet-specific adhesive materials and follow the manufacturer's instructions.
ORDERING INFORMATION
KODAK PROFESSIONAL EI Photographic Satin Print Paper / 160 g
NA = Not available
PHYSICAL CHARACTERISTICS
If you have questions or need assistance, visit Kodak’s website at www.kodak.com/go/lfinkjet or contact your local Kodak
representative.
The contents of this publication are subject to change without notice.
Roll
Length
Roll Width / CAT No.
24 in.
(71 cm)
36 in.
(91.4 cm)
42 in.
(106.7 cm)
50 in.
(127 cm)
54 in.
(137.2 cm)
60 in.
(152.4 cm)
100 ft (30.5 m) NA 128 5824 182 0703 877 3608 188 4188 115 7668
16.4 ft (5 m)
(sample)
NA 179 3132 NA NA NA NA
Physical Characteristics Value Test Method Reference
Caliper 7 mil (178
µ
m) ISO 534
Opacity >90 Tappi T 524
CIE Whiteness 96 Tappi T 524
Weight 160 g/sm ISO 536
Brightness >92 Tappi T 524
60-degree Gloss 40 ISO 7668
L*(D65/10 uvi/BBW) >95 Tappi T 524
Operating Conditions
59-86
°
F (15-30
°
C), 20-70% RH
(non-condensing)
Recommended Storage Conditions 68
°
F (20
°
C), 50% RH
Kodak, Kodak Professional, and Digital Science are trademarks.