Kambrook DURAGLIDE KI820 - Manual (Page 8)

8
Operating Instructions
continued
Stand the iron on its heel and turn the
Temperature Control to MIN.
Plug the power cord into a 230V or
240V power outlet and switch on.
Select the temperature setting
required by rotating the Temperature
Control dial so that the desired setting
is aligned with the Temperature
Indicator.
The Heating Indicator light will
illuminate while the irons heats to the
selected temperature.
Once the light has switched off, the
iron has reached the set temperature
and is ready for use. The light will cycle
on and off during use as the iron
maintains the temperature selected
on the Temperature Control.
CAuTION: The iron
incorporates a thermal
safety fuse to protect
the iron from over-
heating. However the
iron should not be left
unattended while it is
connected to the power
outlet. Special care
should always be taken
when there are children
in the home/vicinity of
the iron.
IMpORTANT: Never
leave the iron
unattended while it
is connected to an
electrical outlet.
Steam Ironing
When filling the iron with water, ensure
that the iron is unplugged. Set the
Steam Control to the DRY position and
holding the iron at an angle use the
water cup supplied to fill the water
tank. Never exceed the maximum
water level as indicated (MAX) on the
side of the water tank.
Tap water can be used in your
Kambrook DuraGlide™ Anodized Iron
unless it is particularly hard, in which
case it is recommended that distilled
or demineralised water be used.
To Operate the
Steam Control
As per the indications on the
Temperature Control and in
Table A (See section ‘Setting the
Temperature’) steam ironing is
only possible at higher ironing
temperatures, indicated with Cotton/
Linen on the Temperature Control.
Plug the power cord into a 230V or
240V power outlet and switch the
power on.
Set the Temperature Control to the
required position within the steam
range and wait until the Heating
Indicator Light has gone out.
Set the Steam Control (on top of the
handle) to the required setting.
Your Kambrook iron is now ready for
use.