Shindaiwa EB212 - Manual (Page 15)

15
Eng
lish
a
Ir fIlter
Level 1.
Tools required: 25-50 mm (1-2 in.) Cleaning brush.
NOTE
Clean daily.
Close choke (Cold Start Position [ ]). This prevents dirt from enter-
ing the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from air cleaner area.
Remove air filter cover. Brush dirt from inside cover.
Remove air filter and lightly brush debris from filter. Replace filter if
it is damaged, fuel soaked, very dirty, or the rubber sealing edges are
deformed.
If filter can be reused, be certain it:
• Fits tightly in the air filter cavity.
• Is installed with the original side out.
Install air filter cover.
f
uel fIlter
Level 1.
Tools required: 200-250 mm (8-10 in.) length of wire with one end
bent into a hook, Clean rag, funnel, and an approved fuel container.
WARNING
Fuel is VERY
flammable. Use extreme care when mixing, storing
or handling.
Use a clean rag to remove loose dirt from around fuel cap and empty
fuel tank.
Use the “fuel line hook” to pull the fuel line and filter from the tank.
Remove the filter from the line and install the new filter.
1.
2.
3.
4.
5.
1.
2.
3.