Sharp R-55TS - Manual (Page 25)

23
SEC R55TS
TINSEA983WRRZ-D32 SEC R55TS
Disconnect the power cord before cleaning or
leave the door open to inactivate the oven dur-
ing cleaning. Ensure the oven is completly cool
before cleaning.
Exterior
The outside surface is painted. Clean the outside
with mild soap and water; rinse and dry with a soft
cloth. Do not use any type of household or abrasive
cleaner.
Door
Wipe the window on both sides with a damp cloth
to remove any spills or spatters. Metal parts will be
easier to maintain if wiped frequently with a damp
cloth and polished dry with a soft cloth. Avoid the
use of spray and other harsh cleaners as they may
stain, streak or dull the door surface.
Control Panel
Wipe the panel with a cloth dampened slightly with
water only. Dry with a soft cloth. Do not scrub or
use any sort of chemical cleaners. Close door and
touch STOP/CLEAR.
Interior
Cleaning is easy because little heat is generated to
the interior surfaces; therefore, there is no baking
and setting of spills or spattering. To clean the inte-
rior surfaces, wipe with a soft cloth and warm wa-
ter. DO NOT USE ABRASIVE OR HARSH CLEAN-
ERS OR SCOURING PADS. For heavier soil, use
baking soda or a mild soap; rinse thoroughly with
hot water. NEVER SPRAY OVEN CLEANERS DI-
RECTLY ONTO ANY PART OF THE OVEN.
Interior
Spatters may occur because of moisture and
grease. Wash immediately after use with hot,
soapy water. Rinse and polish dry. Harder to
remove spatters may occur if oven is not
thoroughly cleaned or if there is long time/high
temperature cooking. If so, you may wish to
purchase an oven cleaner pad with liquid cleaner
within it--not a soap filled steel pad--for use on
stainless or porcelain surfaces. Follow
manufacturer's directions carefully and be
especially cautious not to get any of the liquid
cleaner in the perforations on the wall or ceiling
or any door surfaces.
Rinse thoroughly and polish dry. After cleaning
the interior thoroughly, residual grease may be
removed from the interior ducts and heater by
simply operating the oven using both top and
bottom heaters for 20 minutes without food. See
CONDITION THE HEATER on page 11. Ventilate
the room if necessary.
C L E A N I N G A N D C A R E
- after microwave cooking.
- after grill, bake or automatic cookings.
Waveguide Cover
The waveguide cover is made from mica so requires
special care. Keep the waveguide cover clean to
assure good oven performance. Carefully wipe with
a damp cloth any food spatters from the surface of
the cover immediately after they occur. Built-up
splashes may overheat and cause smoke or possi-
bly catch fire. Do not remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the
oven. To remove, combine 1 cup water, grated peel
and juice of 1 lemon and several whole cloves in a
2-cup glass measuring cup. Boil for several minutes
using 100% power. Allow to set in oven until cool.
Wipe interior with a soft cloth.
Turntable / Turntable Support
The turntable and turntable support can be removed
for easy cleaning. Place your fingers tightly over the
center of the turntable support and lift to remove it
carefully to prevent touching the top heater. If the turn-
table support fits firmly on to the turntable motor shaft,
it may be necessary to twist the turntable support
gently to remove it. Wash in mild, sudsy water; for
stubborn stains use a mild cleanser and a non-abra-
sive scouring sponge. They are also dishwasher-
proof. Use upper rack of dishwasher. The turntable
motor shaft is not sealed, so excess water or spills
should be wiped up immediately.