beautypg.com

Specifications – Sunfire Subrosa SRS-210R User Manual

Page 20

background image

User's Manual

Specifications

Amplifier Output

,700 watts rms

High Cut Filter

30 Hz - 100 Hz adjustable, with a

"Bypass" position

Frequency Response

18 Hz - 115 Hz (-3 dB)

Power Line Voltage

US model

10 VAC 50/60 Hz
International model

30 VAC 50/60 Hz

Dimensions

Amplifier (H x W x D)
1.75" (1U) x 17" x 15"
44.5 mm x 431.8 mm x 381 mm
Subwoofer

14.5" x 44.5" x 3.5"
36 mm x 1130 mm x 88.9 mm

Weight

Amp: 18.4 lb. (8.35 kg)
Sub: 59 lb. (26.8 kg)

Subwoofer Finish

High gloss, ebonized rosewood

Line Power Consumption:

800 watts average, at maximum continu-

ous output. 8 watts at idle
,700 watts peak, time limited basis

Output Levels:

Greater than 110 dB peak SPL (includes

room gain) from 18 Hz to 100 Hz. Mea-

surement is one meter, anechoic.
A typical Sunfire subwoofer can be

expected to ‘best’ its specified minimum

peak SPL by several decibels.

Total Harmonic Distortion

Typically less than 1/10 of the funda-

mental between 18 to 80 Hz.

Input Sensitivity (full output):

50 mVrms from left input with volume

control at 0 dB, 60 mVrms volume con-

trol fully clockwise

*

0.75 Vrms from right input with volume

control at 0 dB, 00 mVrms volume

control fully clockwise

*

Input Impedance:

30 kΩ for Line-Level inputs
56 kΩ for Hi-Level inputs
40 kΩ for XLR input, each leg balanced

to ground

XLR Input

Pin 1 Ground

Pin Positive

Pin 3 Negative

Drivers: dual 10 inch

Extra large neodymium magnets and

long throw mechanical design yield very

high back-emf. The result is extraordi-

narily high operating efficiency – that is,

more acoustic output for each watt of

input.

Internal System Gain:

50 dB from left input jack to speaker

with volume control at 0 dB, 6 dB with

control fully clockwise

*

40 dB from right input jack to speaker

with volume control at 0 dB, 5 dB with

control fully clockwise

*

*

The Sunfire subwoofer utilizes dif-

ferential gain on the left and right

inputs to retain both L+R and L-R

information.

1 VDC Trigger Input

Input voltage range: 5 -18 VDC

Impedance: approx 600 Ω

(20 mA @ 12 V)

Removable terminal block, and one 1/8”

Mono minijack, tip positive.

© 2007 Sunfire Corporation.

All rights reserved. Sunfire Corporation

reserves the right to improve its products

at any time. Therefore, specifications are

subject to change without notice.

Manual 913-15-00 Rev C

0