Sharp HT-SL50 - Manual (Page 14)

9
1
7
6
5
4
3
2
1
9
HT-SL50
E-13
2011 February 24
Plug the AC power cord into an AC outlet, the stand-by
indicator turns red.
This unit will automatically power on if:
1. TV or similar component which supports HDMI CEC, is
turned on.
2. audio signal is detected from Audio input.
The stand-by indicator turns blue.
Notes:
● HDMI input will override the Audio input signal.
● Audio input will function only when there is no signal
from HDMI input.
The audio return channel (ARC) enables an HDMI ARC-
capable TV to send the audio stream to the HDMI OUT
jack of the receiver. To use this function, your TV must
support the ARC.
Volume can only be controlled from your TV.
This unit will automatically go to stand-by mode if:
1. TV or similar component which supports HDMI CEC, is
turned off.
2. no signal from Audio input is detected after 1 minute.
General Control
Make sure to enable the HDMI CEC when making HDMI connection.
To turn the power on
Audio Return Channel (ARC) (Audio
Return Channel submenu)
Volume
Power Off