Sharp HT-SL50 - Manual (Page 10)

9
1
7
6
5
4
3
2
1
9
HT-SL50
E-9
2011 February 24
Installation image:
Place the system as shown.
Remove the protective film covering the sound bar and
subwoofer before using the system.
Notes:
● As the sound from the system is omni-directional, you
can place the speaker anywhere you like. However, it is
recommended to place it as close to the TV as possible.
● The front panel of the speaker is not removable.
Caution:
● Do not change the installation direction when the unit is
turned on.
Placing the system
ACTIVE SUBWOOFER SYSTEM HT-SL50
TV
Blu-ray DVD player
Place the stand as shown.
Placing the stand
ACTIVE SUB WOOFER SY STEM HT-SL50
SUBWOOFER SYSTEM ACTIVE SUBWOOFER SYSTEM HT-SL50 Stand
Make sure to unplug the AC power cord before making any connections.
System connections
Subwoofer
Sound Bar
Right
AC outlet
AC 120 V ~ 60 Hz
Left
White
Red
Speaker connection
Connect the wire without insulation tube to the minus (–)
terminal, and the wire with red and white insulation tube to
the plus (+) terminal.
Caution:
● Use speaker with an impedance of 4 ohms or more, as
lower impedance speaker can damage the unit.
● Do not make a mistake when
connecting the right and left
speakers. The right speaker is
the one on the right side when
you face the unit.
● Do not let the bare speaker
wires touch each other.
● Do not allow any objects to fall
into or to be placed in the bass
reflex duct.
● Do not stand or sit on the subwoofer/sound bar. You
may be injured.
INCORRECT