Sayson Technologies Sayson AltiTouch 390 - Manual (Page 6)

5. Install the phone
If you have installed the stand and are using the phone
on a desk, turn the telephone over so it rests on the
stand. Connect the phone cord to a phone jack and
plug the power adapter into a power outlet.
6. Install on a wall
To install the phone on a wall:
A. Connect the cord to the wall jack.‡
B. Coil the phone cord into the space provided on the
back of the phone.
C. Align the telephone so the hooks on the wall plate
align with the wall-mount slots on the back of the
phone, as shown here.
D. Push the phone onto the pegs, and then slide it
down until it is secure
E. Plug the power adaptor into a power outlet.
Sayson 390/480 for Sphericall User Guide 3
Installation & Setup
For a higher viewing angle, use the slots marked .
For a lower viewing angle, use the slots marked
.
Then rotate the stand towards the phone until it snaps
into place.
3. Connect the cords
If you attached the stand to install the phone on a
desk, route both the phone cord and power adapter
cord through the opening in the stand. Insert the
phone cord into the slot on the back of the telephone
marked
until it clicks into place. Insert the power
cord into the power jack marked .
Note: You should connect the power adaptor to a surge
protector or power bar.
4. Press the cords into the grooves
Press the cords into two of the grooves provided on
the bottom the stand. This will allow the stand to sit
flat on a desk surface.
Sayson 390/480 for Sphericall User Guide 2
‡ Note: You may wish to purchase a short phone cord from a
local supplier for wall installation.