Sony DVP-NS405 - Manual (Page 63)

63
Set
tings
a
nd
Adj
u
st
m
e
nt
s
If you connect a component that does not
conform to the selected audio signal, a loud
noise (or no sound) will come out from the
speakers, affecting your ears or causing the
speakers to be damaged.
◆ DOLBY DIGITAL (DVD only)
Selects the type of Dolby Digital signal.
◆ MPEG (DVD only)
Selects the type of MPEG audio signal.
◆ DTS (DVD only)
Selects whether or not to output DTS signals.
Note
If you select one of the TVS settings while playing
a DVD, the player does not output the following
signals from the DIGITAL OUT (OPTICAL or
COAXIAL) jack.
– Dolby Digital signals (when you set “DOLBY
DIGITAL” in “AUDIO SETUP” to “D-PCM”)
(page 63).
– MPEG audio signals.
D-PCM Select this when the player is
connected to an audio
component lacking a built-in
Dolby Digital decoder. You can
select whether the signals
conform to Dolby Surround
(Pro Logic) or not by making
adjustments to the
“DOWNMIX” item in
“AUDIO SETUP” (page 62).
DOLBY
DIGITAL Select this when the player is
connected to an audio
component with a built-in
Dolby Digital decoder.
PCM Select this when the player is
connected to an audio
component lacking a built-in
MPEG decoder. If you play
MPEG audio sound tracks, the
player outputs stereo signals
via the DIGITAL OUT
(OPTICAL or COAXIAL)
jack.
MPEG Select this when the player is
connected to an audio
component with a built-in
MPEG decoder.
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DOLBY DIGITAL:
MPEG:
OFF
STANDARD
DOWNMIX: DOLBY SURROUND
D-PCM
PCM
DTS: OFF
DIGITAL OUT: ON
OFF Select this when the player is
connected to an audio
component lacking a built-in
DTS decoder.
ON Select this when the player is
connected to an audio
component with a built-in DTS
decoder.