Woodstock SHOP FOX W1709 - Manual (Page 22)

-20-
Table Stop Switches
The table stop switches prevent the table lift
motor from running the table into the sanding
drum and bottoming out the table lift
mechanism at the end of the jack screws.
Periodically adjust the table stop switches.
To adjust table stop switches, do these steps:
1. Apply air to the sander and tension the
sanding belt.
2. Push the down arrow key and lower the
table until you achieve 6 inches between
the sanding drum and the conveyor table
surface. See
Figure 22.
3. Loosen the mounting bolt for the table-
down stop switch and move the switch so
the switch plunger depresses against the
stop block and you hear the switch click.
See
Figure 23.
4. Re-tighten the mounting bolt.
5. Push the up arrow key and raise the table
until you achieve an
1 ⁄
8
inch between the
sanding drum and the conveyor table
surface.
6. Loosen the mounting bolt for the table-up
stop switch and move the switch so the
switch plunger depresses against the stop
block and you hear the switch click. See
Figure 23.
7. Re-tighten the mounting bolt.
8. Use the up and down buttons and test the
table operation and make sure the
switches shut the table lift motor
OFF
when the table is at the minimum and
maximum distance from the sanding drum.
Figure 22. Key pad table-lift controls.
Figure 23. Table stop switch adjustment
locations.
Table Down
Stop Switch
Table Up
Stop Switch
Stop Block
Up and
Down
Key
Switch
Plungers
ADJUSTMENTS
Mounting
Bolt