SPT SD-2201S - Manual (Page 15)

It is recommend t hat you run a was h cy cle with the
dishwasher empt y an d the n remove the plug from the
sock et, turn off the wa ter supp ly and leave the door of
the appliance slightly open. This will help the d oor
seals to ast longer and prevent odours from forming
within the appliance.
If the appliance must be moved, try to keep it in the
vertical position. If absolutely necessary, it can be
positioned on its back.
One of the factors that cau se odors to form in the
dishwasher is food th at remains tr apped in the seals.
Periodic cleaning with a damp sponge will prevent this
from occurring.
After every wash, turn off the water supply to the
appliance and leave the door slightly op en so that
moisture and odors are not trap ped inside.
Before cleaning or performing maintenance, always
remove the plug from the socket.
To cle an the e xterior a nd rubber p arts of the di shw asher,
do not use solvents or abrasive cle ani ng products.
Only use a clo th with warm so apy water.
To remove spots o r stains from the surface of the
interi or, use a cloth da mpened wit h water with a little
vinegar, o r a cleaning pro duct mad e speci fically for
dishwashers.
After Every Wash
Remove the Plug
No Solvents or Abrasive Cleaning
Moving the Appliance
Seals
When it is not in need for a long time
13
The installation of the pipes
and electrical equipments
should be done by professionals.
Electrical Shock Hazard
Disconnect electrical power before
installing dishwasher.
Failure to do so can result in death
or electrical shock.
The installation position of dishwasher should be near the existing inlet and drain
hoses and power cord.
One side of the cabinet sink should be chosen to facilitate the connection of drain
hoses of the dishwasher.
Cleaning the Spray Arms
The spray arm s can be easily r emoved for periodic cleaning
of the noz zles , to prevent possible clogging. Wash them
under running water and ca refu lly replace them in th eir seats,
checking that their rotary m ovement is in no way imp eded .
Grasp the mid dle of the spray arm, pull it upwards to rem ove
it. Wash the arms under a jet of runn ing water and return them
carefully to their seat. Afte r reassembly, check th at the spray
arms turn free ly. Otherwise , check that they have been
installed correctly.