Scag Power Equipment SFZ - Manual (Page 31)

Section 7
27
7.1 MAINTENANCE CHART - RECOMMENDED SERVICE INTERVALS
* Perform these maintenance procedures more frequently under extreme dusty or dirty conditions.
MAINTENANCE
HOURS
Break-In 8 20 40 100 200 400 Procedure Comments
(First 10)
X Check all hardware for tightness
X Check hydraulic oil level See paragraph 7.2
X Check all belts for proper alignment See paragraph 7.7
X Check hydraulic hoses for leaks Use extreme caution when
checking the hydraulic hoses
See paragraph 2.6
X Check seat belts for damage See paragraph 2.5
X Check engine oil level See paragraph 7.3
X *Clean mower See paragraph 7.10
X Check condition of blades See paragraph 7.8
X Check tire pressure See paragraph 7.9
X Change engine oil and filter See paragraph 7.3
X Check battery, See paragraph 7.6
clean battery posts and cables
X Check belts for proper alignment See paragraph 7.7
X Check Operator Pressence System See paragraph 2.3
X Change engine oil See paragraph 7.3
X Drain hydraulic system, replace See paragraph 7.2
hydraulic oil and filters Use SAE 20W50 Motor Oil
X *Clean air cleaner element See paragraph 7.5
X Check hardware for tightness
X Change engine oil and filter See paragraph 7.3
X Check hydraulic oil level See paragraph 7.2
X Replace engine fuel filter See paragraph 7.4
X Drain hydraulic system, replace See paragraph 7.2
hydraulic oil and filters Use SAE 20W50 Motor Oil
X Adjust electric PTO clutch See Scag Dealer