Sony XR160 - Manual (Page 26)

US
Tips
See page 63 on the recordable time of movies.
You can record photos during movie recording by pressing PHOTO fully (Dual Rec).
[ SteadyShot] is set to [Active] in the default setting.
You can specify the priority face by touching it.
You can capture photos from recorded movies.
You can check the recordable time, estimated remaining capacity, etc., by touching (MENU) 
[Setup]  [ (Media Settings)]  [Media Info].
The LCD screen of your camcorder can display recording images across the entire screen (full pixel
display). However, this may cause slight trimming of the top, bottom, right and left edges of images when
played back on a TV which is not compatible with full pixel display. In this case, set [Guide Frame] to
[On], and record images using the outer frame displayed on the screen as a guide.
To adjust the angle of the LCD panel, first open the LCD panel 90 degrees to the camcorder (), and
then adjust the angle ().
Data code during recording
The recording date, time and condition , and coordinates (HDR-PJ50V) are recorded
automatically on the recording media. They are not displayed during recording. However, you
can check them as [Data Code] during playback. To display them, touch (MENU) 
[Setup]  [ (Playback Settings)]  [Data Code]  a desired setting  .
Shooting photos
When disappears, the photo is recorded.









MODE button
(Movie): When recording a movie
(Photo): When recording a photo
Flashes  Lights up
PHOTO button
 90 degrees (max.)
 180 degrees (max.)
 90 degrees to the
camcorder