Sunbeam FP7820 - Manual (Page 15)

13
DEUTS
CH
EN
GLI
S
H
F
R
ANÇAIS
ES
P
A
ÑOL
IT
ALIA
NO
JAP
ANE
SE
COMP
L & W
A
R
R
Manual Setup
Normally, you can complete the setup procedure using A UTO S ETUP
; however,
if your screen image is still distorted after you perform A UTO S ETUP
or the
Installation CD does not run on your system, perform M ANUAL S ETUP
.
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off while
you are waiting for it to warm up.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button at the bottom of the monitor to display
the initial OSD menu.
4. Use the ‘-’ or ‘+’ button to select the IMAGE LOCK icon and press
the OSD Enter button to access.
5. Use the ‘-’ or ‘+’ button to select COARSE .
Once COARSE becomes highlighted, press the OSD Enter button .
6. Use the ‘-’ or ‘+’ button to manually adjust to correct (as much as
possible) for noise in the video signal then press the ‘Exit’ button to save
the changes.
7. Use the ‘-’ or ‘+’ button to select FINE and press the button.
8. Use the ‘-’ or ‘+’ buttons again to tune the image to your liking.
9. When finished, press the Exit button to exit from the OSD.
You have completed monitor setup.
T710_E_update.fm Page 13 Tuesday, July 9, 2002 4:24 PM