Sherwood P-965 - Manual (Page 31)

ENGLISH
31
To listen in a Dolby Headphone mode
• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel
surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.
Note : Only when the HEADPHONE SELECTOR button is set to the speaker off mode, the Dolby Headphone
mode can be selected.
• While listening with headphones, select the desired Dolby Headphone mode.
• Each time this button is pressed, the mode changes as follows :
DOLBY HEADPHONE 1: This simulates the soundfield as if you were in
a relatively small room with less
reverberations.
DOLBY HEADPHONE 2: This simulates the soundfield as if you were in
a typical listening room with moderate
reverberations.
DOLBY HEADPHONE 3: This simulates the soundfield as if you were in
a large space like theater.
Off : Depending on the signal format which is being input, either the
stereo mode or the 2CH downmix mode is selected.
• Combined with the current mode, the selected Dolby Headphone
mode is activated.
• The desired mode can be selected with pressing the CURSOR UP( )
button only when the OSD menu operation is not performed.
Notes :
• In case of that the original surround mode is “DOLBY DIGITAL EX” or “DTS ES” mode, it will be automatically
changed to “DOLBY DIGITAL” or “DTS” mode.
• Only when playing a stereo (2 channel) source in “PL IIx”, “DOLBY VS” or “DOLBY HEADPHONE” mode, you
can select the original surround mode to be combined with use of the MULTI CONTROL knob or the DSP MODE
UP(
)/DOWN( ) buttons.(However, in case of “PL IIx” mode, you cannot select “PL II”mode.)
• When “PL IIx” mode is selected while playing in “PL II” mode, it will be automatically changed to “DOLBY
DIGITAL” or “BYPASS” mode depending on the signal format which is being input.
• You can set the surround back channel mode according to surround back speaker connection.
• Each time this button is pressed, the mode changes as follows :
1 channel : When a surround back speaker is connected.
(“ ” lights up)
2 channel : When two surround back speakers are connected.
(“ ” lights up)
None : When surround back speakers are not connected.
Note:
• When the surround speaker is set to “None”, the surround back channel is automatically set to None.
SB
SB
Selecting the surround back channel mode as connected
Continued
or
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
STANDBY POWER ON
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1