Snapper 1691998 - Manual (Page 13)

13. Install the new baffle (A, figure 8) in deck on
stone guard using existing hardware. Hardware
may be installed with nut to inside or nut to
outside.
14. On new arbor cover, install on top of weld (A,
figure 9) the largest washer (B O.D.),
spacer (C), lo&washer(D), and nut as shown in
shownwillbeinstalled
in next step).
15. On idler cover bolt, install cover to deck
reusing front taptite screw (G) removed in step 1.
Install flat washer (I) and flange nut
removed in
step 4) to secure belt cover. Tighten flat washer and
flange nut (H) loosened in step 1.
Over Stone Guard
6
8.
a
Carriage Bolt
C. Mower Discharge Opening
Figure 9.
Weld
8. Large Washer, O.D.
Spacer,
D.
E. Nut
F. Large Washer
H. Center Hardware
Flat Washer
J. Flange
11