Snapper 1691998 - Manual (Page 12)

9. Slip the mower drive belt (A, figure 5) around the
bottom groove of double-groove pulley (B).
Install pulley with hub down and secure with
new
6-14 2-l (C) and washers
(D and E) removed in step 5. Make sure
arecorrectlyalignedand
60 ft. Ibs. Use a wood block to prevent the blade
from turning.
10. Reinstall the mower drive belt by pulling on the
spring-loaded idler pulley to provide slack in
belt. With belt installed, adjust the belt stops
from belt and tighten mounting hardware.
Figure 5.
A. Mower Belt
B. Double-Groove Pulley
C.
D. Lockwasher ,
E. Flat Washer
11. The baffle (A, figure 6) is installed in the blower
housing for use with 42” mower. For use with
48” mower, remove the baff le and install in holes
marked 48”.
I
6.
A. Baffle
12. Install wing nut assembly as follows:
a. Remove existing hardware from front end of
stone guard.
b. From inside deck, install new
carriage bolt (E, figure7) through deck, stone
washer, and roller bracket. Then
install the large washer (A), lockwasher (F),
and nut (B).
c. Thread the wing nut (C) far enough onto the
screw so that the locknut (D) can be
threaded on flush with the end of screw.
N O T E
On front-cut riders, do not install cup (G) onto
to retain blower housing. Cup is used only
for tractor applications.
Figure 7.
A. Large Washer E. Carriage Bolt
B. Jam Nut, F .
C. G. Cup
D. Locknut,