Sharp Aquos LC 30HV2U - Manual (Page 36)

35
Basic adjustment settings
Power control
Power Control setting allows you to reduce the display brightness to save energy.
A
• When setting to “Auto”, make sure no object obstructs
the OPC sensor, which could affect its ability to sense
surrounding light.
• “Standard” is factory preset value.
• Return to the previous menu by pressing MENU RETURN.
RECEIVER
POWER
MODE
AV
TV/SAT/DVD
RETURN MENU
SET/
ENTER
TV
ANT-A/B INPUT
SURROUND
FRONT
TWIN
POWER
MTS CC
PICTURE SELECT
SUB TWIN CH
؀
؁
FREEZE MODE
VOL CH
MUTE
MENU
FAVORITE CH
DTV/DVD TOP
SOURCE DTV/SAT
DTV/SAT
VCR REC
A B C D
POWER
MENU
GUIDE
INPUT VOL ؁ VOL ؀
INFO
VIEW
SLEEP LEARN EDIT/
ENT
FLASHBACK
DISPLAY
INPUT
TV VCR CBL
/SAT
/DTV DVD
/LD
1 2 3
4 5 6
7 8 9
100 0
Power control for AV source
Power save
When set to “Save1”, “Save2” or “Auto”, power
consumption is reduced by decreasing picture
brightness.
A
• “Power Save“ may not activate when setting to “Auto”
under bright ambient light conditions.
1
Press MENU.
2
Press a/b to select “Power control”, and then
press SET/ENTER.
3
Press a/b to select “Power Save”, and then press
SET/ENTER.
4
Press a/b to select the desired mode, and then
press SET/ENTER.
5
Press MENU to exit the menu.
Description
The screen darkens slightly to conserve
power consumption.
The screen darkens more significantly to
conserve power consumption.
Screen brightness adjusts according to
the ambient light of the room to conserve
power consumption.
Selected item
Save1
Save2
Auto
MENU
Power control
Power Save [Save1]
Standard
Save1
Save2
Auto
MENU
Power Control
No Signal off [Disable]
Disable
Enable
No Signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU.
2
Press a/b to select “Power Control”, and then
press SET/ENTER.
3
Press a/b to select “No Signal off”, and then press
SET/ENTER.
4
Press a/b to select “Enable”, and then press SET/
ENTER.
5
Press MENU to exit the menu.
• Five minutes before the power shuts down, hazard
warning displays every minute.
A
• “Disable” is factory preset value.
• Return to the previous menu by pressing MENU RETURN.
• When enabled, the system will not start up
again even if a signal is received.