Sharp Aquos LC 30HV2U - Manual (Page 14)

13
Watching TV
Simple operations for watching a TV program
Basic connection
To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections
that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector,
plug it into the antenna terminal at the rear of the AVC System.
A
• The antenna and the cable converter cannot be connected at the same time.
A
OUT
B
A
OUT
B
Connecting the VHF/UHF antenna
Connecting the cable converter
VHF antenna UHF antenna
U/V mixer
AVC System (rear)
Cable TV
Cable converter
A
• Be sure connect the antenna or the cable converter as explained above. Signal reception may fail if not properly
connected.
• Be sure that the cable converter output signal is assigned to the ANT-B input on the AVC System.
• How to change channels when the cable converter output signal is connected to the ANT-B input on the AVC System.
• Press ANT-A/B on the remote control unit to switch to ANT-B.
• You can view an image right after selecting the output channel on the cable converter.
Switching between Tuner A and Tuner B
To watch broadcasts via the two tuners, you can select it by pressing ANT-A/B on the remote control unit.
• While watching a broadcast, press ANT-A/B to view the image received from the other tuner.
• Pressing ANT-A/B while viewing in Twin Picture mode (TV image and video image) with TV selected will display the TV
image of the other tuner.
• Pressing ANT-A/B while viewing Twin Picture with video selected will not change the image displayed.
• Pressing ANT-A/B while viewing Twin Picture with two TV images displayed will not have any effect.
• Pressing ANT-A/B while viewing Twin Picture with two video images displayed will switch the selected screen to a TV
image.
The coaxial cable is already
connected at the time of
purchase.
AVC System (rear)